Products for Concrete Analysis & Design
VisualAnalysis with Design
VisualAnalysis supports the analysis and design of all types
of reinforced concrete structures. It includes design support for
beams and columns as well as flat slabs or walls in bending.
Code checks are based on US design specifications by ACI.
| Learn More | Free-Trial | Buy Now! |
Note: IES does not have
any products that specifically support post-tensioned or
pre-stressed concrete design.
ShapeBuilder
Analyze the cross-section of a member to determine structural properties or get stress distributions for eccentric loads. This powerful little utility can help you determine the capacity and stress-strain distribution in reinforced concrete sections. It produced cracked-properties as well as interaction diagrams for just about any cross-section and rebar pattern.
QuickRWall
The best tool on the market for retaining walls, propped cantilevers, basement walls, and even for investigation of buried tank walls, is QuickRWall. The tool will design and provide basic detailing for the concrete reinforcing according to IBC (ACI) or CSA (Canadian) criteria.
QuickRFooting
This stand-alone tool will design spread footings under a
single column. The tool will design and provide basic
detailing for the concrete reinforcing according to IBC (ACI) or
CSA (Canadian) criteria.
QuickConcreteWall
For reinforced concrete shear or bearing walls, IES provides QuickConcreteWall. This tool handles special boundary elements and will produce the wall interaction diagram. The tool will design and provide basic detailing for the concrete reinforcing according to IBC (ACI) or CSA (Canadian) criteria.